| Specifications︰ | Operation
1. Plan your work site.
Work safely and save effort by planning your work before hand. Have your logs positioned where they can be easily reached. Have a site located to stack the split wood or load it onto a nearby truck or other carrier.
2.Prepare the logs for splitting.
This splitter accommodates logs up to 520mm in length. When cutting up limbs and large sections. do not cut sections any longer than the specified length. Do not attempt to split gree logs. Dry , seasoned logs split much more easily. And will not jam s frequently as green wood (moisture)
3.Route the power cord
Locate an appropriate power outlet and secure an adequate extension cord, if needed. Route the cord from the log splitter to the power source in a way that safeguards agaist tripping on the cord. or the cord becoming damaged during the work session. Be sure to avoid wet conditions.
4.Position splitter securely
Be sure the splitter is positioned firmly on level, solid supporting platform,60-70cm high.Without any objects, which could prevent freedom of movement for the operator while working. Never operate the machine on the ground because this may arise the risk of the injury to the face due to the splinter or rubbish and make the operation difficult. Therefore we recommend using a special log splitter platform. If necessary, block the wheels with wedges to prevent them from rolling.
5.Open the Air Bleed
Loosen the BLEED SCREW whenever the splitter is being used. Retighten this crew when you are finished.
6.Place log onto splitter
Place the log onto the splitter. Lengthwise and lying flat on the Main Body. The log should lie flat on the splitter and be cradled by the log splitter, and be cradled by the log guiding plates. Never attempt to split a log at an angle. Be sure the wedge and log pusher will contact the log suarely on the ends.
7.Two hand operation
Depress the Electric Motor Start Swith with one hand. Wait a few seconds ans the motor spins up and creates pressure in the Hydraulic pump. Then . When it is safe to do so, depress the operating Handle. The log pusher will compress the log, pushing it against the Wedge, splitting the log. Once the log is split, release both the electric motor start switch and the operating handle ; this will alow the log pusher to retract.
Warning:
If the log dose not split immediately , do not force it by maintaining the thrust for more than a few seconds. This can damage the tool. It is better to try repositioning the log on the splitter, or setting the log aside.
8. Stack as you work
This will provide a safer work area, by keeping it uncluttered. and avoid the danger of tripping or damaging the power cord.
9.Remember
To retighten the BLEED SCREW when finished. |
|
|
|
